Foam-Cure 1 Ounce
Description
FOAM-CURE is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed its curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours. FOAM-CURE works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.
Manufacturer information
Compatible vehicles
Alternate part numbers
Here are some alternate part numbers and product codes that you may find this part listed under on other sites:
707336141000
707336141000
Additional details
Shipping weight
1.40 ounces
39.69 grams
0.09 pounds
Package dimensions
6.50 x 1.20 x 1.20
⚠️ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov ⚠️