Pro Connector Soldering Jig
Description
This jig quickly and securely clamps, holds, and releases these connectors for your soldering tasks.
This Jig clamp holds the most RC connectors
XT60
Deans T connector
TRA connector
EC-2 to EC-5
Deans Micro 2pin to 4pin connectors
Bullet connectors from 2 to 6.5 mm
Magnetic two piece design with alligator clips and solder storage
Two alligator clips style holding clamps for wire.
Wide Aluminum base for added stability
Can be use as motor holder fit both 5mm and 1/8 motor shaft.
1) soldering iron is must be very HOT!
2) Tin the wires and the connector pins with 60/40 electrical solder
3) Now place the wire and connector pin together with the help of a very hot soldering tip the solder will melts
4) Then remove the soldering tip from the solder join, and let it cool done
Warning
The most dangerous is to connect positive and negative wires together creating a short circuit.
1) One of the wires must be properly isolated at all times.
2) Only clamp on one pin at a time from the same battery.
description revised by: DB September 25, 2014
Manufacturer information
All warranties and guarantees, including missing items, are handled directly by the manufacturer of that item. Should there be any problem with a product, you (The Customer) will need to contact the manufacturer to obtain service. Manufacturer contact information is available upon request. We must be contacted for a return authorization number before returning items for any reason. We cannot accept returned items that have been opened or are not in their original sealed factory containers.
Alternate part numbers
Here are some alternate part numbers and product codes that you may find this part listed under on other sites:
Additional details
Shipping weight
7.25 ounces
205.48 grams
0.45 pounds
Package dimensions
7.00 x 3.75 x 1.00
⚠️ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov ⚠️